Part Number : NPD04S

802.3af/at Active POE 12V/19V/24V Gigabit Splitter

PCBA Model : ( BPL-1513 )

Only PCBA Board

Introduction

The 802.3af/at POE 12V/19V/24V Splitter is designed to run Gigabit speed PoE cables over long distances. This device splits the PoE signal into separate data and power sources and relays them into non-PoE devices. Supports DC output voltage 12V, 19V and 24V via DIP switch three range adjustable. It delivers Power over Ethernet (Gigabit Ethernet) to remote devices. This PD splitter allows a non-POE compliant device to upgrade to PoE, it is used to deploy remote non-PoE device with no nearby AC outlets brings lots of convenient.

Highlight Features

  • Complying with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX, IEEE 802.3ab 1000Base-T, IEEE 802.3at PoE+, IEEE 802.3af PoE standards.
  • Max Power Transmission after split power & data : 27Watts for DC output.
  • Supports 10/100/1000Mbps Gigabit Ethernet speed.
  • DC Output Voltage: 12V / 19V /24V three range adjustable.
  • With hardware protection design the device will not cause any damage while changing the voltage output during operation.
  • Up to 100 meters (328 feet) application.
  • Supports Ethernet PoE to Separate to only Power and only Data output.
  • LED indicators for DC output voltage display of 12V/19V/24V.
  • Over Voltage protection and Short Circuit Protection.
  • Plug and Play, no software required
  • Supports desktop or wall mounting installation and multiple units combination.

Hardware Specification

Product 802.3af/at POE 12V/19V/24V Splitter
Main Chip Solution Microsemi PD70200 + LT3891
Standard IEEE 802.3 10BASE-T

IEEE 802.3u 100BASE-TX

IEEE 802.3ab 1000BASE-T

IEEE 802.3af Power over Ethernet

IEEE 802.3at Power over Ethernet Plus

Network Media 10BASE –T: UTP Cat. 3 or up

100BASE-TX : UTP Cat. 5 or up

1000BASE-T: UTP Cat.5e or up

Data Transfer Rate 10/100/1000Mbps (Half-duplex),

20/200/2000Mbps (Full-duplex)

Data Pin 1/2, 3/6 & 4/5, 7/8
PoE Type Input : End-span (Type-A): PIN 1/2,3/6 ;

Mid-span (Type-B): PIN 4/5,7/8

Power Interface Input : RJ45 POE in

Output : DC out

Power Requirement 44~57 PoE Power Source
DC Output Voltage 12V/ 19V/ 24V three range adjustable
LED Definition DC Output LED  x3

l DC 12V output: 12V Light on

l DC 19V output: 19V Light on

l DC 24V output: 24V Light on

Temperature Operating : 0° to 55° C ; Storage: -40° to 70° C
Humidity Operating : 10% to 90% non-condensing

Storage: 5% to 90% non-condensing

Dimension

( W x D x H )

NPD04S : 84.48*80*39.5mm

BPL-1513 : 58.89*73mm

Weight NPD04S : 99.8g

BPL-1513 : 48.4g

Case of material ABS
Certifications TBD

** Specifications can be negotiated separately according to needs.

** Specifications can be negotiated separately according to needs.